5
6
Insert hitch pin through the hole at one end of the axle. Slide a
7/16" flat washer
onto the axle, then a wheel, then another
7/16" flat
washer
. Slide the axle through the bushings on the bottom of the short legs. At the end of the axle add a
7/16" flat washer
, wheel,
another
7/16" flat washer
and finally the
hitch pin
.
Axle
7/16" flat washer
Axle Bushing
Carefully stand the unit up onto it’s legs.
Adjust the
position of the legs on the leg sockets so that the unit will sit at a slight downward angle toward the grease drain in the smoke
chamber. Now fully tighten all four leg bolts.
REMEMBER, THE LEGS ARE NOT FULLY TIGHTENED AND CAN FALL OFF.
Grease
Drain
Page 9
