Copyright 2010. All Rights Reserved.
www.okinausa.com
7
REV012011-V03
Construction
Die-Cast Aluminum Alloy
Coating
Ivory Powder Stove
Power / Transformer*
24V AC (+/-10%), 60VA
Power Consumption
16 Watts
Dimension
16.73”(L) x 6.30”(W) x 6.50”(H) / 425mm(L) x 160mm(W) x 165mm(H)
Camera Space
7.87”(L) x 4.33”(W) x 4.53”(H) / 200mm(L) x 110mm(W) x 115mm(H)
Weight
7.72 lbs / 3500g (w/out bracket) / 11.75 lbs / 5330g (with bracket)
Specifications are subject to change without notice
*Power Supply / transformer not included
NOTE 1:
IR light distances are entirely dependent upon environmental site conditions and the location at which the unit is situated.
The type of camera being used is also very important.
NOTE 2:
Factory default for the IR LED activation level is 80%. If there is not enough IR light, adjust the
VR
level to maximum 100%.
PACKAGE CONTENTS
One (1) SHM-7540LPDN-IO Camera
One (1) Allen Wrench
One (1) CS Ring
One (1) DC Cord
One (1) HI11-TKHBL IR Illuminator Housing
One (1) Fully-Cable Managed Bracket
One (1) Main Accessories Pack
Three (3) Rust-proof Stainless Steel Wall Screws
Three (3) Rust-proof Stainless Steel Mounting Screws
Three (3) Stainless Steel Washers
Three (3) Plastic Washers
One (1) Allen Wrench
One (1) Secondary Accessories Pack
Three (3) Screw-on Connectors
One (1) Rubber Pad
One (1) Rust-proof Stainless Steel Camera Screw
One (1) Plastic Washer
One (1) Operational Manual
One (1) OSD User Manual
One (1) User’s manual
*
For any returns, please include all components listed above with original packaging in
Resalable Condition
.
Absolutely No Returns
will
be accepted if any component is missing/damaged or if any cable is cut or tampered with.
CAUTIONS
1. Never point the camera toward the sun
Do not expose the lens directly to the sun or to strong light as this may damage the pick-up device.
2.
Handle this camera with care
Avoid any shock or bumping of the camera. Improper handling could damage the camera.
3.
Requires a proper operating environment
This camera is designed for outdoor or indoor use. The allowable temperature range for operation of this camera is between
14
F ~ 122
F / -10
C ~ 50
C and the allowable humidity is 80%RH maximum.
4.
Clean the front face to the pick-up device
It is recommended that the pick-up device surface be cleaned before lens installation or whenever the lens is changed. Cleaning should
be done by using a chamois, a very fine soft cloth, lens tissue, or cotton tipped applicator and ethanol to carefully remove any fingerprint
or dust.
5.
Check the power source voltage
The power source voltage should be within the specified range. (Camera must meet the specifications). Camera must be connected to a
surge protector at all times.
6.
Objects and liquid entry
Never push objects of any kind into this camera as this may touch dangerous voltage points of short out parts that could result in a fire or
electric shock. Never spill any kind of liquid on the video product.
7. Servicing
Do not attempt to service this video product by yourself as opening or removing covers may expose you to dangerous voltage or other
hazards. Refer all service to qualified servicing personnel.
