Cabling Systems & Solutions
UTP = Unshielded Twisted Pair
Rev092007 VGE01
Installation:
1. To have the best picture and quick installation, please use STP cable. There is no need to adjust Dip switch
when using STP (shielding twisted pair) cable.
2. Please make sure to follow this instruction for DIP switch setting when using CAT5 UTP cable. Please
disconnect the wiring between the receiver to the monitor once the picture is not normal, otherwise it may
cause your monitor to be damaged.
3. Dip switch setting at receiver unit only when using with UTP cable.
4. Please disconnect the receiver from the monitor once the picture is abnormal or when there is no picture
display. You can increase the stage of Dip switch at the receiver and re-connect it again.
5. DIP Switch Level
6. If you are not able to get good picture after adjusting the dip switch on the receiver unit, the solution is to
replace the cable for an STP cable.
7. Improper setting may cause no picture display.
8. After properly setting the unit, you could adjust the contrast and brightness of the monitor for the best picture
quality.
1 2 3 4 5
---------------------
↓↓↓↓↓
1
↑↓↓↓↓
2
↓↑↓↓↓
3
↑↑↓↓↓
4
↓↓↑↓↓
5
．
．
．
．
．
．
↑↓↑↑↑
30
↓↑↑↑↑
31
↑↑↑↑↑
32
2. screw off of the D-SUB , then
connect the ground cable
3. Screw back the D-SUB, then plug
RJ45 connector.
