Page 1
DISPENSER KIT COMPONENTS
(USED ON DIRECT THERMAL AND
THERMAL TRANSFER UNITS)
STEP
PROCEDURE
1.
Switch the printer
OFF
and disconnect the power cord.
2.
Raise the top cover and print head assembly.
3.
Remove the front door panel.
4.
Raise the tear bar to the upright position to unlock the Platen Roller
Assembly.
Refer to the illustrations on the following pages.
5.
Gently lift the right side of the platen from the support yoke, then
maneuver the geared left side to free from the opposite support yoke.
6.
Note the position of the components. The new Dispenser Plate will
replace the existing Tear Bar on the Platen Roller Assembly.
Detach "C" rings from both ends of the platen and slide off the gear and
bearings. Remove the existing tear bar.
7.
Install the dispenser plate in the same location as was the tear bar.
Replace bearings and gear and reattach "C" rings.
8.
Install the altered platen assembly back into the printer.
TEXT CONTINUED ON PAGE 4
DISPENSER
KIT
DISPENSER
PLATE
GUIDE SHEET
Direct Thermal Unit: For Thermal Transfer Unit see page 6
Installing the Dispenser Kit
