Oki PRO330S, User Manual

Page: 98 / 280

- 98 -
Aligning the paper sensor
Checking the position of paper sensor
The position of the paper sensor varies with the paper to be used.
Refer to the table below to check the set position and adjust the paper sensor accordingly.
• If the cut type setting of the machine do not match the position of the sensor, a paper jam will be falsely detected.
In that case, check the type of the paper loaded in the machine on the operator panel, and adjust the position of
the sensor accordingly.
To load paper with a black mark...... Change the positions of the upper sensor and the lower sensor so that they do not overlap.
To load paper with a hole............... Change the positions of the upper sensor and the lower sensor so that they do not overlap.
Media type Sensor position
Settings from the printer driver or
operator panel*
PAPER FORM CUT TYPE GAP LENGTH
Paper with a
black mark on
the printing
side
Upper: Position of the black mark
Lower: Position where it does
not overlap with the
black mark on the front
CONTINUOUS
PAPER
B/M (FRONT) -
Paper with a
black mark on
the back
Upper: Position where it does
not overlap with the
black mark on the back
Lower: Position of the black mark
CONTINUOUS
PAPER
B/M (BACK) -
Paper with a
hole
Upper: Position of the hole
Lower: Position of the hole
CONTINUOUS
PAPER
SIDE HOLE
CENTER HOLE
-