Oki Pro1040, Maintenance Manual

Page: 26 / 118

- 26 -
If Other Messages Are Displayed
⿟ If Other Messages Are Displayed
Other messages and error codes, cause of errors and their resolutions, and status of the ATTENTION
lamp are described below.
Besides, when "Please see HELP for details" is shown in the message, pressing the <HELP> button in
the control panel will show the solution procedure, and you can easily solve the process according to
the guidance. Refer to ”Operating the Help screen” (P.11) for details.
Memo
z
Meanings of the symbols used in the error messages are as follows.
- [COLOR]: Either yellow, magenta, cyan, black, or white
*
appears.
*: White appears only for the Pro1050.
- [MENUCOLOR] : Y,M,C,K (Pro1040) / Y,M,C,K,W (Pro1050)
- [COVER]: Either top cover or unwinder cover is displayed.
- [ERRCODE]/ [CODE]: Detailed numbers of the error are displayed.
- [SENSOR_ERROR]: Detailed information about the error is displayed.
Message displayed on the
display screen
Error
code
ATTENTION
lamp
Causes and Troubleshooting
Reference
pages
Close Cover
[COVER]
310
589
Blinking The cover shown in the message is
open.
Close the cover.
-
Power Off/On
[ERRCODE]:Error
- Blinking A fatal error has occurred.
Restart the printer.
If 188 appears in [ERRCODE], check the
condition of the unwinder’s installation.
-
Service Call
[ERRCODE]:Error
-
Print Cartridge Not Installed
[COLOR]
Please see HELP for details
6940
6941
6942
6943
6944
Blinking The print cartridge is not installed
properly.
Press the <HELP> button, and solve
according to the guidance shown on the
Help screen.
-
Check Print Cartridge
[COLOR]
Please see HELP for details
3400
3401
3402
3403
3404
Blinking Print cartridge has not been set
correctly.
Install the print cartridge correctly.
-
Invalid Print Cartridge Order
Set to [MENUCOLOR]
7382 Blinking The print cartridge is not installed in
the correct position.
Reset in the order that is displayed in
the display screen.
-
Unnecessary Print Cartridge
Error
The job was cancelled. Check
the position of the print cartridge
lift up lever.
To turn off the display, press OK
button
Please see HELP for details
7390
7391
7392
7393
7394
7395
7396
Blinking The Lift Up Lever of the print cartridge
is not in the correct position.
Printing was stopped and the print data
was deleted.
Press the <HELP> button, and solve
according to the guidance shown on the
Help screen.
User's Guide
The job was cancelled due to a
spot color order mismatch
To turn off the display, press OK
button
Please see HELP for details
7385 Blinking Printing was stopped and the data was
deleted because the spot color settings
were different from those specified in
the printer driver.
Press the <OK> button to delete the
display on the display screen.
Press the <HELP> button, and solve
according to the guidance shown on the
Help screen.
-