– –
■
Initializing Settings
Set the push switch as described below to initialize the
setting information.
Push the switch for one to five seconds while running
under normal operating mode. The green and red LEDs
will flash with a regular pattern. After that, push the
switch once again in that state to turn OFF both of the
red and green LEDs. This will return the settings of
the interface board to their default, or ex-factory, set-
tings. After the interface board has been initialized, the
printer will automatically reboot itself.
■
LED Display
Green : Lights when other party connection is
recognized as 00BASE-TX.
Red :
Lights when packets are received.
Push Switch
LED
11-5. Wireless LAN Interface Model
ON
ON
OFF
OFF
DIP-SW
Switch
Function
ON
OFF
-
Command emulation (Ster Line mode)
Always ON
-
Should not be changed (Should be set to on)
-
Should not be changed (Should be set to on)
-
Sensor adjustment
Invalid
Valid
-
Should not be changed (Should be set to on)
-6
Handshaking conditions (conditions for
BUSY)
Offline or receive
buffer full
Receive buffer full
-
Should not be changed (Should be set to on)
-
Should not be changed (Should be set to on)
-
Low-power consumption mode
Invalid
Valid
-0
Should not be changed (Should be set to on)
The factory settings of DIP switch are all on.
No. 1 2 3 4 5 6 7 8
No. 1 2 3 4
9 10
DIP-SW 1
DIP-SW 2
Summary of Contents for OkiPos 407II
Page 1: ......
