Oki OKIFAX 5400, Maintenance Manual

Page: 370 / 448

DESCRIPTION OF
PRINT OPERATIONS
40838301TH Rev.1 B - 16
B.3.2.4 2'nd Tray Communication Error
This error is generated if on sending a command to the 2'nd tray is returned no-status (40s) or an
undefined status. However, in case there is no status when reset, it will be considered that the 2'nd
tray is not mounted.
B.3.2.5 Cover Open
Cover open sensor "0" indicates an open cover.
When the cover is closed the CU (control unit) section sends the reset signal and processes in the
same way as if the power has been turned on.
B.3.2.3 Paper Feed Monitoring
Status
Paper supply error
Paper outlet jam 1
Paper outlet jam 2
Description and Supervising Sensor
Indicates monitoring error in hopping.
Hopping is retried 3 times. 118 mm or less path
36 (hopping) x 3
Transport system jam 1
Transport system jam 2
Transport system jam 3
Paper size error
Indicates an error in the paper transport path.
Error on resist roller section.
From resist ON to write sensor (PS2) ON.
From inlet sensor OFF up to write sensor OFF.
30 mm or less
Inlet ~ write +20
44 mm or less
Distance
Indicates an error in the paper transport system.
Error of transfer roller and/or heat roller.
From write sensor ON to outlet sensor ON.
Indicates paper size other than specified one.
From resist ON to inlet sensor OFF.
207 mm or less
Write ~ 69
Recording paper +/- 45 mm
Recording paper +/- 45 mm
135 mm or less: NG
Supervises slipping of the recording paper.
From outlet sensor ON to OFF.
Supervises jamming at the near paper outlet.
From outlet sensor ON to OFF.
When a crumpled recording paper is detected, the
outlet sensor is set to "OFF" earlier than usual.