10
4. Lift the lock lever (
1
) on the right tractor (
2
) and
move the tractor over to correspond to the width
of the continuous forms you are using. Center the
paper support (
3
) between the two tractors.
5. Open both tractor covers and place the first three
holes in the continuous forms paper over the pins.
Important!
Make sure that an equal number of paper holes
are engaged on each tractor. If not, the paper
will jam.
6. Close the tractor covers and fine tune the position
of the right tractor until the holes in the paper are
centered on the pins, then push back the right
tractor lock lever.
7. Lower the platform.
8. Position the continuous forms stack below the
printer with no more than about 1 inch (3 cm)
offset (
1
).
Tearing Off Printed Continuous
Forms
1. With the SEL light on, press SHIFT.
The continuous forms move forward onto the
stacker.
2. Tear off the printed form along the perforation.
3. Press SHIFT.
The forms move back into the printer, ready for
printing the next document.
Removing Continuous Forms
1. Follow the steps above to remove the printed
portion.
2. Press SEL.
3. Press LOAD.
The forms move back to the tractors.
4. Lift the platform and remove the forms from the
tractors.
5. Lower the platform.
F5-05a.jpg
F5-06a.jpg
F5-06b.jpg
F5-07a.jpg
F5-08a.jpg
F5-09.jpg
