Oki IP-6620, Maintenance Manual

Page: 17 / 572

OKI Data Infotech Corporation CONFIDENTIAL
Chapter 1 Overview of Maintenance Workflow
1-3
Table 1-2 Jigs
Name Quantity Remarks
Fan-shaped tension gauge (0.1 to 20 N)
Double-side type
(Oba keiki seisakusho)
1 For X motor installation
BeltTension-Jig 1 For adjusting SUS belt tension (push)
Round-type spring tension gauge (50 N) 1 For adjusting Y motor belt tension (pull)
BLOCK-ADJUST-CR 4 - For adjusting the carriage height
- For adjusting the carriage parallelism
BAR-ADJUST-CR 1 Head positioning pin
ADJUST HEAD PIN, MW 1 For adjusting the print heads inclination
WIPING HEIGHT TOOL, MW 1 For adjusting the wiping unit height
SINGLE COLOR FILLING TOOL (MV) 1 For supplying or draining one ink color
CAPPING-SEAL-TOOL (HV) 1 For checking leak tightness of the capping unit
Table 1-3 Consumables
Name Quantity Remarks
Grease for synchro belt and
decelerating belt
1 Grease EM-60L (Dow Corning Toray Co.,Ltd.)
or an equivalent grease (silicon grease can be
used)
Glove or fingerstall 1 pair For protection from ink blot, commercially
available
Cleaning paper As required For wiping ink blot, Kimwipes or equivalent
Ethanol As required For cleaning contacts, etc.
Cap cleaning liquid 1 set Daily maintenance kit
Wiper cleaning liquid 1 set Daily maintenance kit
Cleaning swab 1 set Daily maintenance kit
Dropper 1 set Daily maintenance kit
Cleaning liquid cartridge 6 or 7 The number of necessary cartridges depends
on the number of ink colors
Storage liquid cartridge 6 or 7 The number of necessary cartridges depends
on the number of ink colors