Oki ES9160 MFP, Manual

Page: 40 / 182

2 HOW TO MAKE COPIES
38 Bypass Copying
Bypass Copying
When you make copies on OHP film, sticker labels, envelopes or non-standard size paper, place the copy paper on the
bypass tray. Bypass copying is also recommended for copying on standard size paper which is not set in any of the
drawers.
If you select the paper size, you can utilize various functions such as the automatic paper selection (APS) or the
automatic magnification selection (AMS). For details, see the following page:
 P.173 “Copying Function Combination Matrix”
The operating procedure for bypass copying differs depending on the paper size to be used. See the table below for the
operating procedure of each size.
Open the bypass tray for bypass copying.
If the paper is large, pull out the paper holder.
When placing or removing copy paper, move the paper holding lever toward
the outside. After this, move the paper holding lever back toward the
equipment.
When using thick paper for bypass copying, some thick paper may not be
fed properly. In this case, turn over the paper and place it again as shown in
the figure.