Parts list
(Make sure to check the information below before you start assembling.)
Legs
Seat board
Seat support
Reinforcement bar
Seat back
(Sticker is attached to
front surface)
Frame
Connecting bolt
(M6 × 50 mm)
Actual size
Protective sticker
Note Use a cross-head screwdriver for assembly.
Do not use an electric screwdriver or power tools, as they may damage the product.
Use a manual screwdriver instead.
Assembling the Chair
1
Attaching the legs, frame, seat back, seat support, and
reinforcement bar
Connecting bolt (50 mm)
Frame
Leg
Seat back
Top
Top
Bottom
Bottom
Seat support
Attach so that
this flat side is
facing forward.
Front surface
Reinforcement bar
(Attach so that the side without
the nut holes is facing forward.)
Dowel
(Note about round nuts)
Round nut (embedded in various parts)
Screw hole
Connecting bolt
Turn the
head of the
round nut to
align the
opening with
the screw
hole.
Complete the assembly procedure on one side (right or left) before
proceeding to the other side.
Insert the dowel at the bottom of the frame into the dowel hole at the
bottom of the leg, and use a connecting bolt to secure them together.
Use connecting bolts to secure legs and the top of the frame as
shown in the figure above.
Insert the seat back and seat support into the slot in the leg, and
hand-tighten the connecting bolts.
Insert the dowel at the end of the reinforcement into the dowel hole in
the leg, and use a connecting bolt to secure them together.
Attach the other leg. (Repeat steps to above to attach the other leg.)
Fully tighten the connecting bolts for all parts.
* The locations of each round nut are indicated with a star ( ).