3
INSTALLATION
Before operating
Connect 9V battery or accumulator.
Unpacking
After unpacking, check carefully the transmitter. In the case of any damage do not
use the transmitter and contact immediately the manufacturer.
Parameter settings
Open the transmitter house. Parameters (transmitted code, keying speed, timing
schedule, operation mode and frequency) are set by DIP switch according to the
following table:
This table can be found also on the inner side of the transmitter cover.
Transmitter installation
for foxoring
Unfold approx. 50 cm of antenna
wire and wind the rest of both wires
around the transmitter body. Install
transmitter so that the transmitter
body sits on the ground and the
antenna stands up. The transmitter
should be audible from 50−100m
distance. Check the audibility with
the receiver of average sensitivity.
Be sure that the antenna is in the
free air, otherwise the “final approach“
of competitors could be very difficult!
Transmitter installation
Unfold the antenna (both wires)
and hang the transmitter so that the
antenna (wire close to the indicators)
is up and the end of lower wire is
close to the ground. The whole
radiator should be in free space
(especially during the rain). With the
antenna installed as this, the
transmitter will be audible from the
distance over 1 km.
Clock start
The transmitter is to be started at the beginning of its transmitting period by turning
on (ON/OFF switch). Before this, you must set the timing (DIP switch 8−9) and select
operation mode (DIP switch 10). Other parameters (frequency, code, keying speed)
can be set any time, even while transmitting.
TRANSMITTER PARAMETERS SETTING (I=ON, 0=OFF)
code 12345 code 12345 code 12345 speed 67
A 00000 N I0II0 MOE 0I0II 100 00
B I0000 O 0III0 MOI II0II 70 I0
C 0I000 P IIII0 MOS 00III 50 0I
D II000 Q 0000I MOH I0III 35 II
E 00I00 R I000I MO5 0IIII timing 89
F I0I00 S 0I00I MO IIIII 60/240 00
G 0II00 T II00I 30/120 I0
H III00 U 00I0I 60/60 0I
I 000I0 V I0I0I 12/48 II
J I00I0 W 0II0I
K 0I0I0 X III0I operation 10
L II0I0 Y 000II continuously 0
M 00II0 Z I00II intervals I
freq 1234
3520 III0
3530 I000
3550 II0I
3560 I0I0
3570 0I00
3580 IIII
3590 I00I
3600 0II0
3610 0000
3620 I0II
3630 0I0I
3640 00I0
PARAMETERS
ON
OFF
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
FREQ
9V BATTERY/ACCU
cca 2 m
cca 0,5 m