16
EN
ASSEMBLING AND MOUNTING
1
Assemble the two foot parts crosswise. Remove the four screws from the foot parts.
2
Use the four screws to mount the extension pole onto the feet. Then remove the height adjustment
ring.
3
Slide the stand cover over the extension pole onto the feet. Pull out the extension pole and secure
it by installing and fastening the height adjustment ring.
4
Attach the motor unit to the extension pole and secure it with the screws.
5
Remove the spinner and the plastic nut from the motor unit. Attach the rear guard to the motor
unit.
6
Secure the rear guard with the plastic nut.
7
Slide the fan blade onto the motor shaft so that the pin locks to the groove. Secure the fan blade by
tightening the spinner onto the shaft.
8
Open the clips on the front guard. Hook the front guard onto the rear guard, thereby aligning the
screw holes at the bottom of the guards.
9
Install the screw and nut to lock the guards. Make sure all the clips are closed.
10
Place on a stable level surface. Set the desired angle and height.
OPERATION
11
Plug in the product.
12
Press ON/OFF to switch the fan on. Press SPEED repeatedly to cycle through the fan speeds
(L=Low; M=Medium; H=High). Alternativ you can use the button on the remote control to select
the speed. Press button to turn on/off the product.
13
Press TIMER or button on the remote control for timed operation. Press TIMER or button
repeatedly to set the hours (1, 2, 4 hours) after which the fan should turn off.
14
Press the OSCILLATION / SWING knob to activate oscillation function.
Caution
• The product may only be connected to the mains once it has been completely assembled.
• The appliance must not be disassembled during operation, general care, cleaning and user
maintenance.
• The product may never be operated without the stand or in a horizontal position.
• Switch off and disconnect the product before adjusting height or desired angle.
• The guard must be completely closed when operating the product.
• During operation, do not put fingers or other objects in the guard.
• Unplug if it is not used for some time.
CHANGING BATTERIES
15
Open the battery compartment of the remote control. Insert 2 batteries (not included) of type
LR03 (AAA) observing the + and – polarities as indicated on the batteries and inside the battery
compartment. Close the battery compartment.
IM_OSF443-W_151103_V03_HR.indb 16
3/11/15 9:58 AM
