Ojawa XP-1450, Operation Manual

Page: 10 / 27

XP-Series
10
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION !!
CAUTION :
REPLACE WITH SAME TYPE FUSE AND
RATING. DISCONNECT SUPPLY CORD BEFORE CHANGEING
FUSE.
WARNING :
TO REDUCE THE RISK OF FIRE OR
ELECTIRC SHOCK. DO NOT EXPOSE THIS EQUIPMENT TO
RAIN OR MOISTURE. DO TNO REMOVE COVER. NO USER
SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED PERSONNEL.
CAUTION - HOT SURFACE AVOID CONTACT
MADE IN KOREA
SERIAL
NUMBER
XP-1450
Powered Mixer
XP-Series
2+v1 Outs
®
POWER
ON
OFF
CAUTION :
EXTERNAL SPEAKER
LOAD IMP. MINUM 4 Ω
CHANNEL - 2
Parallel
( 300W / 4 Ohm)
(Above 4Ω)
Speaker Connection
CHANNEL - 1
Parallel
( 300W / 4 Ohm)
(Above 4Ω)
PRIMARY FUSE
T4.0A / 250V
230V 50Hz, 660W
POWER INPUT
CAUTION: TO REDUCE
THE RISK OF FIRE REPLACE
WITH SAME TYPE.
Pin 2
Pin 1
1+
2-(NC)
1-
2+(NC)
PRIMARY FUSE
T8.0A / 250V
230V 50Hz, 1200W
POWER INPUT
CAUTION :
EXTERNAL SPEAKER
LOAD IMP. MINUM 4 Ω
POWER
ON
OFF
CHANNEL - 1
Parallel
( 350W / 4 Ohm)
(Above 4Ω)
CHANNEL - 2
Parallel
( 350W / 4 Ohm)
(Above 4Ω)
CHANNEL - 3
Parallel
( 350W / 4 Ohm)
(Above 4Ω)
Speaker Connection
XP-1750C
Powered Mixer
XP-Series
3+1 Outs
MADE IN KOREA
SERIAL
NUMBER
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION !!
CAUTION :
REPLACE WITH SAMETYPE FUSE AND
RATING. DISCONNECT SUPPLY CORD BEFORE CHANGEING
FUSE.
WARNING :
TO REDUCE THE RISK OF FIRE OR
ELECTIRC SHOCK. DO NOT EXPOSE THIS EQUIPMENT TO
RAIN OR MOISTURE. DO TNO REMOVE COVER. NO USER
SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED PERSONNEL.
CAUTION -
HOT SURFACE AVOID CONTACT
®
CAUTION:
TO REDUCE
THE RISK OF FIRE REPLACE
WITH SAME TYPE.
Pin 2
Pin 1
1+
2-(NC)
1-
2+(NC)
5
5
4
4
1
1
2
2
3
3
▒ REAR PARTS-1/2
(Rear Section) XP-1750C/2050C
(Rear Section) XP-1450
1. POWER SWITCH
Mains switch to turn the XP on or off. Please make sure to set the master faders to their minimum position before
switching the power on. This will save you, your audience, and the equipment from unnecessary stress. In case
additional external equipment is connected to the XP - e.g. power amps, FX units, EQs, etc. - please, proceed in
the following order when switching your equipment on:
1. switch on the FX units,
2. switch on the XP
3. switch on external power amps
When switching the power off, please proceed in the opposite order.
XP-Series 10