Oilon ESi 6-17, Installation And Operation Manual

Page: 22 / 80

Constant
curve mode
LED1
Green
LED2
Green
LED3
Yellow
LED4
Yellow
LED5
Yellow
Constant curve
mode 1
X
Constant curve
mode 2
X X
Constant curve
mode 3
X X X
Changing the operating mode
1. Press and hold the button for more than 2 seconds.
2. Scroll between operating modes by pressing the button.
3. Once you have reached the right operating mode, wait for 10 seconds, and the
setting will be saved.
2.6.8 HVAC checklist
Check the following:
1. All joints are tight.
2. The expansion tanks for the heating system and the filling unit expansion tank have
been installed appropriately.
3. The safety valve discharge pipe and the pressure gauge for the heating system
have been installed appropriately.
4. The heating system has been appropriately filled and bled of air.
5. The brine circuit has been appropriately installed, filled, and bled of air.
2.7 Electrical installation and external sensors
Electrical installation is to be carried out by authorized and trained
personnel only.
When making electrical connections, refer to the connection diagrams supplied with the
unit.
Accessing the unit’s control cabinet
The heat pump’s control cabinet is located inside the heat pump, in the top section of
the heat pump unit.
1. Open the top cover of the heat pump by lifting from the edges.
20 (75) M8010 2204EN