OHM ELECTRIC COOL CABI OCA-S300BC-A100, Instruction Manual

Page: 29 / 44

7
2-3 Attachment of drain hose
Moisture arisen from dehumidification by COOLCABI is discharged through a drain hose.
Pay attention to the following notices in order to attach the drain hose properly.
Caution
If the drain hose is not attached properly, water collected in the drain pan inside the
COOLCABI may overflow into the control panel interior.
- Let a drain hose go directly downward without kinks and windings..
- The free end of a drain hose should be directly downward without bending.
- To prevent a hose from coming off, insert it deep enough to a drain pipe.
- In case the joint of a drain hose and a drain pipe is not tight enough, use a hose
band to fix the joint securely.
- Adjust the hose length so it end does not submerge in the container.
- Empty the container frequently especially on
humid days.
2-4 When Adjustable Louver is used
Attachment of the Adjustable Louver enable to direct output air to the desired direction.
Note: Cooling capacity may decrease up to 5% by using the louver.
To keep the set angle not to be affected by external impact including vibration,
the base plate and the louver top is rather tightly fitted.
1) When straight wind is desired, use the
base plate only. The head of louver
base plate will protrude from
the fan mounting surface by 40mm.
2) When angled wind is desired, attach the louver top on the base plate and adjust
the direction by turning the louver top. The louver blades are angled at 25 degrees.
The locking system of louver top works at every 45 degrees. Pay attention that
short circuit can occur depending on the louver position.
The head of louver top will protrude from the fan mounting surface by 70mm.
Base plate
Louver top
Attention: Do not put excessive force on drain pipe when working.
Internal fan mounting plate
Upwardly directed
Sideway directed
45°
Base plate
Screw x4
Internal fan mounting plate
Enclosure
COOLCABI
Enclosure
WATER
COOLCABI