background image

2

1

Put the motorcycle on a work stand so that the 
front wheel barely touches the ground.

2

Remove the front fender, brake calipers, speed 
sensor and the front wheel. Refer to the vehicle 
service manual for correct procedure.

Mou tI g I stRuCtIo s

  arninge!

We strongly recommend to let an authorized 

Öhlins dealer install this product.

  arninge!

If you work with a lifted vehicle, make sure that it 

is safely supported to prevent it from tipping over.

  otte!

1

When you work with this product, see the 

vehicle service manual for vehicle specific 

procedures and important data.

  otte!

1

Before you install this product clean the vehicle.

3

Measure the distance from the top of the outer 
fork leg to the top of the upper triple clamp. 
Note this distance.

  otte!

1

It is very important that the Öhlins front fork is 

installed at the exact same posiition as the OEM 

front fork.

4

Loosen the bolts to loosen the upper and the 
lower triple clamps.

5

Remove the fork legs from the motorcycle.

3

6

4

2

6

Apply Loctite 243 or similar to the bolts. Install 
the supplied fender brackets to the fork legs, 

see figure 6. Tighten the screws to 4 Nm.

7

Install the fork legs in the triple clamps at the 
same position as measured in step 3. Turn the 
handle bars fully from side to side to make sure 
that nothing restricts the movement, and that 
the throttle cable and the wire harness run in 
smooth bends.

  otte!

1

The eccentrically machined surfaces on the 

outer tube must be at a 90º angle from the 

vehicle direction.

Bracket

21665-17

Bracket

21665-17

Bracket

21665-09

Bracket

21665-09

2x bolt 

01046-38 

Loctite 243

Torque 4 Nm

2x bolt 

01046-38 

Loctite 243

Torque 4 Nm

2x bolt 

01046-38 

Loctite 243

Torque 4 Nm

2x bolt 

01046-38 

Loctite 243

Torque 4 Nm

Reviews: