Ohio Medical Corporation, 1111 Lakeside Drive, Gurnee, Il 60031-4099 (800)662-5822—Fax: (847) 855-6218
www.ohiomedical.com —– 550107 (Rev.5) 08/2005
3
1. INSTRUCTIONS FOR USE
PRIOR TO INITIAL USE
Upon receiving your new Moblvac
®
III-cs, perform the following initial tests to ensure that your unit is
in good working order and that no damage has occurred during shipment.
SET UP INSTRUCTIONS
Your Moblvac
®
III-cs has been shipped with some minor assembly required. A 3/32” Allen wrench is
the only tool required.
1.
Visually inspect all components for physical damage that may have occurred during shipping.
2.
After removing all components from their cartons, insert the backpole assembly into the back
of the Moblvac
®
III-cs base.
3.
Align the two “collection mounting brackets” located at the top of the backpole assembly to-
wards the front of the unit.
4.
Tighten the 10-32 set screw located at the back of the base assembly with a 3/32” Allen
wrench.
5.
Connect the tubing from the bottom of the backpole to the safety overflow trap assembly.
6.
Plug the power cord into an electrical outlet. Depress the “POWER” switch and listen to verify
that the pump starts.
7.
Plug the vacuum port located at the top of the backpole and adjust the vacuum level by turning
the vacuum regulator knob. Verify that the vacuum gauge reflects a charge in vacuum level
while turning the regulator knob.
8.
Depress the “POWER” switch to turn the unit OFF (O).
9. Place a collection canister bracket (ring) in the slide mounting bracket of the backpole assembly or
pedestal stand and insert a collection canister.
IMPORTANT: This device is for use only by persons properly trained in medical suction
techniques and in the operations of suction equipment. Improper use could cause injury.
Thoroughly read this operations manual to familiarize yourself with the Moblvac
®
III-cs
before using the device.
DANGER: POSSIBLE EXPLOSION HAZARD IF USED IN THE PRESENCE OF
FLAMMABLE ANESTHETICS.
