SCOUT
TM
SERIES BALANCES - SKX EN-3
2.4 Connecting Power
AC Adapter Installation
AC power is used to power the scale when battery power is not needed. First, connect the AC
Adapter (supplied) to the AC Adapter Input receptacle at the rear of the balance then connect
the AC plug to an electrical outlet.
Figure 2-3. Rear and bottom view of balance
Battery Installation
Install the four “AA” batteries with polarity as shown in the battery compartment.
Note:
After power on, it is recommended to let the balance warm up for at least 5 minutes before
using it.
2.5 Initial Calibration
When the Balance is first installed, and when it is moved to another location, it must be
calibrated to ensure accurate weighing results. The balance can be manually calibrated with
external masses. Have the appropriate calibration masses available before beginning
calibration. Refer to the Calibration Section for masses and calibration procedure.
AC Adapter Input Jack
Battery Compartment Cover
Interface Connection
Security Switch
Weigh Below Hole
Security slot (Anti-theft lock slot)
