OHAUS Dafender 3000 i-DT33P, Instruction Manual, Page: 15 / 60

Defender 3000 Indicators EN-13
2.3.2 EasyConnect
TM
Indicator
To connect an OHAUS EasyConnect
TM
scale base to an i-DT33P or an i-DT33XW EasyConnect
TM
indicator,
plug the base's connector into the external load cell connector located at the back (i-DT33P) or bottom (i-
DT33XW) of the indicator
. Then rotate the base connector’s locking ring in the direction of the arrows
demonstrated below.
Note : For connecting bases which do not support EasyConnect
TM
to an EasyConnect
TM
indicator, contact an
authorized OHAUS dealer to obtain a load cell cable gland kit (P/N 30379716) as an accessory.
2.3.3 Non-EasyConnect
TM
Indicator
To connect a non-EasyConnect
TM
scale base to an i-DT33P or an i-DT33XW non-EasyConnect
TM
indicator,
follow the instruction in Open the Housing section to open the housing first before proceeding.
Note : For connecting EasyConnect
TM
bases to a non-EasyConnect
TM
indicator, contact an authorized OHAUS
dealer to obtain a load cell cable gland kit (P/N 30427858) as an accessory.
2.3.3.1 i-DT33P
1. After opening the housing, release the load cell connector (circled) on the rear of the indicator and then
pass the load cell cable through it.
Figure 2-1 i-DT33P
Figure 2-2 i-DT33XW