OHAUS CS 2000, Operating Manual

Page: 5 / 40

5
Declaration of Conformity We, Ohaus Corporation, declare under our sole responsibility that
the balance models listed below marked with "CE" are in conformity with the directives and
standards mentioned.
Marked with: EC Directive (Including applicable amendments) Standard
73/23/EC EN60950:1992
Electrical equipment for use within specified Safety of Information
voltage limits Technology Equipment
89/336/EC EN61326:1997 + A1:1998
Electromagnetic compatibility Electrical Equipment for Measure-
ment, Control and Laboratory Use
- EMC requirements
Immunity - Performance Criterion B
Emission - Class B
ISO 9001 Registration for Ohaus Corporation .
Ohaus Corporation, USA, was examined and
evaluated in 1994 by the Bureau Veritas Quality International (BVQI) and was awarded ISO 9001
registration. This certifies that Ohaus Corporation, USA, has a quality system that conforms with the
international standards for quality management and quality assurance (ISO 9000 series). Repeat
audits are carried out by BVQI at intervals to check that the quality system is operated in the proper
manner.
Ted Xia
President
Ohaus Corporation, Pine Brook, NJ USA
Last two digits of the year which the CE marking was affixed: 02
Ohaus Corporation, 19A Chapin Road, P.O. Box 2033, Pine Brook, NJ, 07058-2033
,
USA
Scale model (s)
Compact CS 200, CS 2000 and CS 5000
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-- Consult the dealer or an experienced radio/TV technician for help.