3
INSTRUCTION MANUAL
1.
Place the CHANNEL CHRONO PUSHER on a flat and stable surface. Connect the
power supply via the input powercon connector (1). The Power indicator led (2) will turn
on. Make sure the power connector supports the power of the FX Machine(s) you want
to control.
2. Verify the safety key (6) is in OFF position and switch on the device(s) to the power out
connector (4). Ensure the consumption of all the machines which must be activated
at the same time don’t exceed the maximum allowed of 20A resistive load or 15A of
inductive load.
3. Remove the safety key to avoid undesired shootings.
BASIC PUSHER OPERATING
1. Insert the safety key (6) and switch the device on (ON position).
2.
Press the flash button (7) to activate the device. During the operation the led current
output (5) will light up.
TIME COUNTER: TOTAL MODE
1. The time counter (12) in total time mode will show you at all time the total time of the
activations you have made. Check the total time mode led (14) is switched on. If not,
press the total time button (13).
2. The display will show you the total time of the activations in “Minutes:seconds:hundredths”
format.
3. If you would like to reset the counter to 00:00:00 press the “reset button” (18).
THE TIME COUNTER: COUNTDOWN MODE
If you know the duration of your CO2 bottle, insert it in the 1 CHANNEL CHRONO PUSHER
and you will know the remaining time of the bottle all along. The time counter (12) in
countdown mode will show you at all time the time left of your CO2 bottle.
1. Verify the countdown mode led (16) is on. On the contrary press the countdown button
(15).
2.
To introduce the duration of your CO2 bottle press the counter editor buttons (17).
Each button changes the value of the next digit. The format shown in the screen is
“Minutes:seconds:hundredths”.
3.
In each activation the display will show the remaining time and will start flashing when it
reaches at 00:00:00.
4.
To reset the counter at the time you have specified press the “reset” button (18).
5.
If at any time you click the counter editor buttons (17) again, the 1 CHANNEL CHRONO
PUSHER will take that value as the default time.
SET UP
OPERATION AND OPERATING METHODS
