Ofs Staks benching assembly, Manual

Page: 6 / 15

6 ofs.com imagine a place® 800.521.5381 Assembly instructions
Staks benching assembly
1. Install privacy screens into tool rails.
2. Use a RUBBER MALLET to work screen all the way in until seated on the bottom extrusion.
Privacy screen installation
3. Loosen T-nut screws and slide back H-base for access to bottom of toolbar.
4. Insert end caps into outside ends of tool rails.
5. Secure in place by threading set screw through the small hole in the end of the toolbar
and into the flange on the inside face of the end cap.
6. Reposition H-base and re-tighten T-nut screws.
7. The toolbar will again be flush to the H-base. The end cap will extend past the H-base.
End caps ship with tool rail kit.
Part #: 1565102