Plug the charger into an AC 110V/230V wall outlet or a DC 12V power source. The
charger power is on now and the LCD displays the MAIN MENU.
The LCD displays the data below.
If you need to stop charging, press the S(START) button to stop it, and then press
the START button to go back to the MAIN MENU.
*
When the battery pack is fully charged or discharged, you can press the
S(START) button to RE-PEAK or RE-DISCHARGE the pack.
*
After the battery pack has peaked, press the
(ENTER) button, the LCD will
show MAX. voltage during charging.
*
If the battery pack is not connected to the charger before
charging, the LCD will show an ERROR massage.
*
If the cell number you selected does not match the battery pack,the LCD will show
an ERROR massage in Li-Po or Pb mode.
*
If the cell number you selected is not coincident to the Li-Po or PB battery pack,
the LCD display will show an Error message.
1.When the number of the battery pack>select number, the LCD
display will show "[Error] OVER VOLTAGE".
2.When the number of the battery pack<select number, the
charger will charge battery pack at 0.3A about for 2 min..
If the battery voltage is still over low, the LCD display will
show "[Error] LOW VOLTAGE".
1.Using the + (INCREASE) / -(DECREASE) button to select the battery type you
want and connect the charge lead of the charger to the connector of the battery
pack..
2. Then, press the
(Enter) button into the mode you selected .
NI-CD CHARGE
C=2.OA
1
2
3
4
[Error]
OVER VOLTAGE
[Error]
OPEN CIRCUIT
[Error]
LOW VOLTAGE
CHG 00 : 00 00000
NC+ 2.00A
xx. xxV
1
2
3
4
5
6
7
A
B
C
D
Function Button
Operation Signal
INCREASE
+
DECREASE
-
ENTER
START
S
FLASH
'
'
1:Battery type
2:Charge status
3:Charge current
4:Cell count(Li-Po & Pb only)
1:The charger is in the charge condition
(CHG:Fast Charge/DHG:Discharge)
2:Time (sec)
3:Capacity(mAh)
4:Battery type
5:Charge status s:Fast Charge
-:Discharge
*
:Charge after Discharge )
6:Charge / Discharge rate
7:Battery Voltage(V)
NI-CD CHARGE
C=2.0A
NI-MH CHARGE
C=2.0A
LI-PO CHARGE
C=2.0A
7.4V
TONE ENABLE
PB CHARGE
C=2.0A
12.0V
+
+
+
+
+
-
-
-
-
-
3
Operation Instruction
Main Menu
