OFITE, 11302 Steeplecrest Dr., Houston, TX 77065 USA / Tel: 832-320-7300 / Fax: 713-880-9886 / www.ofite.com
10
c. Locate the two power conversion switches on the circuit board. Switch
both of these switches to the appropriate voltage (switch them both to the
right for 115V and to the left for 230V). Refer to the photo on page 9.
d. Replace the side panel.
2.
To change the roller speed, open the unit casing as described
above and turn the Speed Control Knob (clockwise to increase and
counter-clockwise to decrease). Use a hand-held tachometer to verify the
speed setting.
3.
OFITE Roller Ovens are fused to protect the driving motor, heaters and
the controller. The light in the fuse holder will glow when the fuse burns
out. The fuse holders are located above the roll and heat switches. The
one on the left is for the heater and the one on the right is for the motor.