Office Star Products Pro-Line II ProGrid Back Manager's Chair, Operating Instructions

Page: 2 / 2

1
2
3
4
5
6
7
8L
8R
9
9
10
10
11
17
16
15
15
13,9,10
12
14
© Office Star Products January 2012
PART QTY
1.
Base . . . . . . . . . . . . . . . . . . . . . . . 1
2. Casters . . . . . . . . . . . . . . . . . . . . . 5
3. Pneumatic Cylinder . . . . . . . . . . . . 1
4. Bellows . . . . . . . . . . . . . . . . . . . . . 1
5. Mechanism . . . . . . . . . . . . . . . . . . 1
6. Seat Cushion . . . . . . . . . . . . . . . . . 1
7. Back . . . . . . . . . . . . . . . . . . . . . . . . 1
8. Arms (8L & 8R) . . . . . . . . . . . . . . . 2
9. Flat Washers . . . . . . . . . . . . . . . . . 3
10. Star Washers . . . . . . . . . . . . . . . . 3
11. Mechanism Screws . . . . . . . . . . . 6
12. Short Back Support Screw . . . . . 1
13. Long Back Support Screw . . . . . . 1
14. Plastic Cover Screw. . . . . . . . . . . 2
15. Knob . . . . . . . . . . . . . . . . . . . . . . 2
16. Plastic Cover . . . . . . . . . . . . . . . . 1
17. Back Support . . . . . . . . . . . . . . . . 1
18. Allen Wrench (not shown) . . . . . . 2
Remove all parts from carton, separate by part numbers indicated on parts list, and verify part quantities.
STEP 1 Insert five Casters (2) into Base (1), push hard until you feel or hear the Caster (2) snap into place. Insert Pneumatic Cylinder (3) into Base (1) and slip
Belows (4) over Pneumatic Cylinder (3).
STEP 2 Align holes of Arms (8L & 8R) with holes of Seat Cushion (6), secure Arms (8L & 8R) using one Knob (15), one Flat Washer (9) and one Star Washer (10) for
each Arm (8), FULLY TIGHTEN ALL KNOBS (15).
STEP 3 Attach Mechanism (5) to Seat Cushion (6) with the arrow towards the front of the chair using six Mechanism Screws (11),
FULLY TIGHTEN ALL SCREWS.
STEP 4
Attach Back Support (17) to Back (7) using one Short Back Support Screw (12), Secure Plastic Cover (16) over Back Support (17) using two
Plastic Cover Screws (14). Insert Back Support (17) into rear of Mechanism (5) and secure using one Long Back Support Screw (13), one Flat Washer (9) and one
Star Washer (10).
FULLY TIGHTEN ALL SCREWS.
STEP 5 Place the assembled seat on top of Pneumatic Cylinder (3) and apply downward pressure.
ATTENTION: MAKE SURE ALL SCREWS ARE FULLY TIGHTENED BEFORE USING CHAIR.
®
92343
ProGrid BACK MANAGER’S CHAIR
ASSEMBLY INSTRUCTIONS