© Office Star Products February 2012
PART QTY
1.
Base . . . . . . . . . . . . . . . . . . . . . . . 1
2.
Casters . . . . . . . . . . . . . . . . . . . . . 5
3.
Pneumatic Cylinder . . . . . . . . . . . . 1
4.
Bellows . . . . . . . . . . . . . . . . . . . . . 1
5.
Mechanism . . . . . . . . . . . . . . . . . . 1
6.
Seat Cushion . . . . . . . . . . . . . . . . . 1
7.
Back Assembly . . . . . . . . . . . . . . . 1
8.
Arms (8R & 8L) . . . . . . . . . . . . . . . 2
9.
Short Screws . . . . . . . . . . . . . . . . . 2
10.
Medium Screws . . . . . . . . . . . . . . 8
11.
Long Screws . . . . . . . . . . . . . . . . 4
12.
Spacers . . . . . . . . . . . . . . . . . . . . 2
13.
Back Support (pre-installed) . . . . 1
14.
Allen Wrench (not shown) . . . . . . 1
Remove all parts from carton, separate by part numbers indicated on parts list, and verify part quantities.
STEP 1
Insert five Casters (2) into Base (1), push hard until you feel or hear the Caster (2) snap into place. Insert Pneumatic Cylinder (3) into Base (1) and
slip Bellows (4) over Pneumatic Cylinder (3).
STEP 2
With the arrow towards the front of the chair align two Spacers (12) between Seat Cushion (6) and Mechanism (5) and secure using two Medium
Screws (10) at the front of the Mechanism and two Short Screws (9) at the back.
REFER TO STEP 2 OF DRAWING.
FULLY TIGHTEN ALL SCREWS USING ALLEN WRENCH (14).
STEP 3
Attach Back Support (13) to Seat Cushion (6) on top of Mechanism (5) and secure using four Long Screws (11).
FULLY TIGHTEN ALL SCREWS USING ALLEN WRENCH (14).
STEP 4
Attach Arms (8L & 8R) to Seat Cushion (6) using three Medium Screws (10) for each Arm (8R & 8L).
FULLY TIGHTEN ALL SHORT AND LONG SCREWS BEFORE PROCEEDING.
STEP 5
Place the assembled seat on top of Pneumatic Cylinder (3) and apply downward pressure.
ATTENTION: MAKE SURE ALL SCREWS ARE FULLY TIGHTENED BEFORE USING CHAIR.
STEP 1
STEP 4
STEP 5
STEP 2
STEP 3
4
1
3
3
2
10
9
5
12
6
11
5
6
13
10
8
8
EM20522
SCREEN BACK TASK CHAIR WITH ARMS
ASSEMBLY INSTRUCTIONS
DO nOT pull chair from
straps on backrest.
