583713/583814 MESH BACK CHAIR
ASSEMBLY INSTRUCTIONS
© Office Star Products November 2006
PART
QTY
1. Base . . . . . . . . . . . . . . . . . . . . 1
2. Casters . . . . . . . . . . . . . . . . . . 5
3. Pneumatic Cylinder . . . . . . . . . 1
4. Mechanism . . . . . . . . . . . . . . . 1
5. Seat Cushion . . . . . . . . . . . . . . 1
6. Back Assembly . . . . . . . . . . . . 1
7. Arms (7L & 7R) . . . . . . . . . . . . 2
8. Flat Washer . . . . . . . . . . . . . . 13
9. Short Screws . . . . . . . . . . . . . . 3
10. Long Screws . . . . . . . . . . . . 10
11. Back Support (Pre-Installed) . 1
12. Allen Wrench (Not Shown) . . 1
Remove all parts from carton, separate by part numbers indicated on parts list, and verify part quantities.
STEP 1
Insert five Casters (2) into Base (1), push hard until you feel or hear the Caster (2) snap into place.
Insert Pneumatic Cylinder (3) into Base (1).
STEP 2
Attach Mechanism (4) to Seat Cushion (5) with the arrow pointing towards the front of the chair, using four Flat Washers (8), and Four
Long Screws (10).
TIGHTEN ALL SCREWS COMPLETELY USING ALLEN WRENCH (12).
STEP 3
Attach Back Support (11) to Mechanism (4) using three Flat Washers (8), and three Short Screws (9),
FULLY TIGHTEN ALL SCREWS USING ALLEN WRENCH (12).
STEP 4
Align the holes in the Arms (7L & 7R) with the holes in the Seat Cushion (5), Attach Arms (7L & 7R) to Seat Cushion (5) using three Flat
Washers (8) and three Long Screws (10) for each arm.
FULLY TIGHTEN ALL SCREWS USING ALLEN WRENCH (12).
STEP 5
Place the assembled seat on top of Pneumatic Cylinder (3) and apply downward pressure.
ATTENTION: MAKE SURE ALL SCREWS ARE FULLY TIGHTENED BEFORE USING CHAIR.
DETAIL A
1
2
3
4
5
6
7L
7R
8,10
11
8,10
8,10
9
8
11
5
4
8,10
8,10
