Office Star Products 43808, Operating Instructions, Page: 2 / 2

43808 MULTI FUNCTION ERGONOMIC CHAIR
ASSEMBLY INSTRUCTIONS
© Office Star Products August 2006
DETAIL A
STEP 1 STEP 2
STEP 3
STEP 4
STEP 5
1
2
3
4
6
12
11
15L
15R
13
13
14
14
7
5
3
5
9,8,10
16
11
11
Part QtY
1. Base . . . . . . . . . . . . . . . . . . . . . . . 1
2. Casters . . . . . . . . . . . . . . . . . . . . . 5
3. Pneumatic Cylinder . . . . . . . . . . . . 1
4. Bellows . . . . . . . . . . . . . . . . . . . . . 1
5. Seat Cushion . . . . . . . . . . . . . . . . . 1
6. Back Cushion . . . . . . . . . . . . . . . . 1
7. Mechanism . . . . . . . . . . . . . . . . . . 1
8. Washer . . . . . . . . . . . . . . . . . . . . . 1
9. Back Cushion Bolt . . . . . . . . . . . . . 1
10. Lock Washer . . . . . . . . . . . . . . . . 1
11. Back Cushion Post . . . . . . . . . . . 1
12. allen Screw . . . . . . . . . . . . . . . . . 1
13. Phillips Head Screw . . . . . . . . . . . 6
14. Mechanism Screw . . . . . . . . . . . . 6
15. arms Left (15L) right (15r) . . . . 2
16. Back Support (Pre-Installed) . . . . 1
17. allen Wrench (Not Shown) . . . . . 1
Phillips Screwdriver also needed
for assembly (not provided)
Remove all parts from carton, separate by part numbers
indicated on parts list, and verify part quantities.
STEP 1 Insert five Casters (2) into Base (1), push hard
until you feel or hear the Caster (2) snap into place. Insert
Pneumatic Cylinder (3) into Base (1). Slip Bellows (4) over
Pneumatic Cylinder (3).
STEP 2
Attach Seat Cushion (5) to Back Cushion Post
(11) using Allen Screw (12).
TIGHTEN SCREW
USING ALLEN WRENCH (17).
STEP 3
Attach Arms (15L & 15R) to Seat Cushion (5)
using three Phillips Head Screws (13) for each arm. Attach
Mechanism (7) to Seat Cushion (5) using six Mechanism
Head Screws (14) with back support towards the back of Seat
Cushion (5). TIGHTEN ALL SCREWS COMPLETELY.
STEP 4 Place the assembled seat on Pneumatic Cylinder (3) and apply downward pressure.
STEP 5 Insert the Back Cushion Post (11) into Back Support (16), and secure using Back Cushion Bolt (9), Washer (8),
and Lock Washer (10). TIGHTEN BOLT USING ALLEN WRENCH (17).
ATTENTION: MAKE SURE ALL SCREWS ARE FULLY TIGHTENED BEFORE USING CHAIR.