TM
© Office Star Products August 2011
2
3
5
4
10
9
6
8
1
PART QTY
1.
Base . . . . . . . . . . . . . . . . . . . . . . . 1
2.
Caster . . . . . . . . . . . . . . . . . . . . . . 5
3.
Pneumatic Cylinder . . . . . . . . . . . . 1
4.
Mechanism . . . . . . . . . . . . . . . . . . 1
5.
Seat Cushion . . . . . . . . . . . . . . . . . 1
6.
Back Cushion . . . . . . . . . . . . . . . . 1
7.
Arms (7L & 7R) . . . . . . . . . . . . . . . 2
8.
Arm Knob w/ Washer . . . . . . . . . . . 2
9.
Mechanism Screw . . . . . . . . . . . . . 4
10.
Back Support Screw w/ Washer . 3
11.
Back Support (pre-installed) . . . . 1
12.
Allen Wrench . . . . . . . . . . . . . . . . 1
11
7L
7R
8
Remove all the parts from carton, separate them into part numbers indicated
on the list and make sure part quantities are correct.
STEP 1
Insert five Casters (2) into Base (1), push hard until you hear or feel Caster (2) snap into place. Insert Pneumatic Cylinder (3) into Base (1).
STEP 2
Attach Arms (7L & 7R) to Seat Cushion (5) using one Arm Knob w/ Washer (8) for each Arm (7).
FULLY TIGHTEN ARM KNOBS w/ WASHER (8).
STEP 3
Attach Mechanism (4) to Seat Cushion (5) using four Mechanism Screws (9).
FULLY TIGHTEN ALL MECHANISM SCREWS (9).
STEP 4
Attach Back Support (11) to rear of Mechanism (4) using three Back Support Screws w/ Washers (10).
FULLY TIGHTEN BACK
SUPPORT SCREWS w/ WASHERS (10).
STEP 5
Place the assembled seat on top of Pneumatic Cylinder (3) and apply pressure.
ATTENTION: MAKE SURE ALL SCREWS ARE FULLY TIGHTENED BEFORE USING CHAIR.
54666
24/7 HIGH INTENSITY USE CHAIR
ASSEMBLY INSTRUCTIONS