Important notes
Wrist orthosis
without thumb piece
The Dynamics wrist orthosis without
thumb piece
provides effective wrist im-
mobilisation. The open design also ensures
finger mobility. Three-dimensionally moulded
inner padding guarantees pleasant wearing
comfort.
Please note
–
The initial adjustment and strapping on of the
product must be carried out by qualified specialist
staff. The aluminium splint can be moulded when
cold.
– If the product has to be worn in combination with
other products, please discuss this with your doctor
beforehand.
–
If you experience an unpleasant sensation, intense
pain or any other problem when wearing the product,
then remove it and contact your doctor or specialist
supplier.
– We use a comprehensive quality management system
to check our products. However, should there still be
reason for complaint, please contact your special-
ist supplier.
Dear user,
We are pleased that you have chosen a
product from Ofa Bamberg and would like
to thank you for putting your trust in us.
Please take a moment to read through this
product information carefully to ensure
optimum effectiveness of your Dynamics
product.
Ofa Bamberg wishes you a speedy
recovery!
←
Fitting instructions
The fitting instructions in pictures can be found
on the fold-over page at the beginning of the
brochure.
1
To put on the orthosis, open all Velcro tapes and pull
them through the corresponding eyelet. Pull the or-
thosis over the wrist in such a way that the hand and
thumb opening are pointing away from your body and
the contoured aluminium splint is on the inside of
your wrist.
2
First close the Velcro tape around the wrist, then the
upper and lower Velcro tape. The middle Velcro fastener
can be adjusted afterwards if necessary. Please ensure
that the product is secure but not too tight in order to
prevent pinching.
24_DYN_Handgelenkorth_ohne_545105026_ble_20190415_7587.indd 8
08.05.2019 10:00:13
