Oeuf 1M6D-C, Manual

Page: 17 / 18

17
fold on dotted line
center of dresser
Classic:
714 MM./ 28 inches
Sparrow, Fawn & Robin: 724mm / 28 1/2 inches from the floor
The most secure attachment of the bracket is when at least one of the screws can go into a stud in the
wall. If the screws provided are not long enough to reach the stud, you will need to provide a longer
screw. To attach to a stud, measure 711 mm (28 inches) from the floor and attached the bracket using
the center hole.
If you can not locate a stud or the position would be too impractical, please use the anchors provided and
follow the instruction below. The anchors are designed for sheetrock and brick/concrete walls.
1. Determine where you want the dresser positioned.
2. Find the center of the dresser from side to side and mark the wall with a pencil. (The center is located
at the center of the bracket you just attached to the dresser!)
3. For Sparrow, Fawn and Robin bases measure 724 mm (28.5 inches) from the floor at the center mark.
For Classic base measure 714 mm (28 inches) from the floor at the center mark.
4. Position the template so the intersection of the dotted lines is at your last mark on the wall.
5. With a pencil, mark the wall at the two “+”.
6. Remove the template and drill two 6 mm (1/4 inch) holes at the two marks.