A S S E M B lY
3
STEP 1:
Using four 14 mm bolts, washers and
nuts, install one caster in each square
hole on the bottom edge of both the
right and left support
G
&
K
. Be sure the
square bolster on the post of each castor
inserts fully into the square hole in the
support before tightening.
STEP 2:
Using four 14 mm bolts and washers,
attach the bolt plate on the right support
G
to the bracket on the tube support
J
, ensuring that the castors are facing
down. Be sure bolts are securely
tightened before proceeding.
STEP 3:
Slide left support tube
K
into the tube
support
J
and secure with 17 mm
bolt and curved washer
L
. The curved
washer should lay flat against the tubing.
STEP 4:
Laying the top tray
A
upside down on
the floor, attach the mounting bracket
on silver adjusting tube
E
to the bracket
on the bottom of the tray, being sure the
groove in the adjusting tube faces away
from the center of the top tray.
STEP 5:
Now, slide the silver adjusting tube
with the top tray attached into the tube
support
J
and secure at the desired
height with the T-bolt
F
.
STEP 6:
Attach four rubber protector bumpers
B
by pushing the black plastic pins
provided into the holes in the corners of
the top tray. The pins are inserted from
outside the tray toward the inside, being
sure the rubber bumpers overlap the top
edge of the tray.
STEP 7:
Install the four small rectangular plastic
inserts
C
into the reinforcement bars
under the top tray. Then install the
four large rectangular plastic inserts
H
into the four holes on the left and right
supports
G
&
K
.
You are now ready to use your new
portable tray.
