3
Operating Instructions and Parts Manual
24893 / 24894
9/17
2017 OEMTOOLS
™
24"/30" OUTDOOR OSCILLATING
WALL MOUNT FAN
22. The procedures documented in this manual
are to serve as guidelines for the use of this
equipment.
23. The use of this equipment is simple and
straightforward if you follow the instructions.
When operating this equipment, use common
sense, and only use this equipment for its
intended purpose.
PRODUCT DESCRIPTION
The OEMTOOLS
™
24"/30" Outdoor Oscillating
Wall Mount Fan features a water-resistant motor
for circulating air in workshops, garages and
other structures, where the fan may be subjected
to splashing water or very light rain.
PRODUCT SPECIFICATIONS 24"
30"
Weight
31.3 Lbs.
32.9 Lbs.
Speeds 3
Output Power
1/7 HP
Voltage
120V / 60Hz
Current 2.0A
CFM
6800 7200
RPM 1080
Sound Pressure Level (dB) 74
76
Ingress Protection
(IP) Rating IP44
UL Listed E302275
CONTENTS
(1) 24" Outdoor Oscillating Fan, (1) Wall Mount
Assembly, Mounting Hardware, (1) Instruction
Manual
SPECIFIC SAFETY INSTRUCTIONS
AND WARNINGS
WARNING
:
Thoroughly read and understand the
provided product manual before attempting to
use this product.
WARNING
:
DO NOT attempt to disassemble,
repair or modify this fan.
WARNING
:
DO NOT insert your hand or other
objects into the fan guard or near moving parts.
WARNING
:
DO NOT submerge this fan in liquids.
WARNING
:
DO NOT touch this fan with wet
hands.
WARNING
:
DO NOT use this fan if the cord or
plug has been damaged.
WARNING
:
Ensure the wall mount is fastened to
a concrete wall or stud capable of supporting the
weight of the fan.
WARNING
:
Fit the front and rear guards to the fan
prior to attempting to start the fan.
1. DO NOT unplug this fan by holding the cord.
Unplug this fan by holding the plug.
2. DO NOT plug this fan into an extension cord.
3. DO NOT operate near an open flame or
heat source.
4. DO NOT use this fan in conjunction with a
solid-state speed control device.
5. DO NOT leave this fan plugged in while
unattended. Always unplug the fan when
not in use.
6. DO NOT move or attempt to perform
maintenance while this fan is plugged in.
ASSEMBLY INSTRUCTIONS
NOTE: Remove all contents from the box and
reference the parts list to ensure that all parts are
present.
1. Wall installation.
WARNING
:
DO NOT mount on dry wall.
CONCRETE WALL INSTALLATION
a) Mark the desired hole location using
the Wall Mounting Bracket, then drill the
holes.
b) After drilling, insert the wall anchors and
tap them until flush with wall face.
c) Position the Wall Mounting Bracket and
screw the 3 bolts into the anchors. Tighten
the bolts securely.
