3
Operating Instructions and Parts Manual
24816
PORTABLE BUCKET-TOP
PARTS WASHER
6/17
2017 OEMTOOLS
™
PRODUCT DESCRIPTION
The Portable Bucket-Top Parts Washer is designed to attach to
any standard 5-gallon bucket, as an efficient way to clean small
parts and tools.
PRODUCT SPECIFICATIONS
Basin Diameter:
13.5"
Pump:
120VAC, 60 Hz, .23A
Fitment:
Standard 5 Gallon Bucket
Hose Length: 46"
Cord Length:
72"
CONTENTS
Washing Basin, Flow-Through Brush, Hose, (2) Hose Clamps,
Submersible Pump.
SPECIFIC SAFETY INSTRUCTIONS
AND WARNINGS
1. The recirculating pump is designed for non-corrosive, water-
based cleaning agents. DO NOT use corrosive, flammable or
solvent-based cleaning agents as the pump will malfunction
and may catch fire.
2. Do Not reuse cleaning solution. Change fluid frequently.
3. Clean the parts washer after each use; flammable and
combustible residues from parts and tools may contaminate
cleaning solution.
4. Do Not leave parts washer unattended while the pump is
plugged-in and operating; the pump may become clogged
and overheat presenting a risk of fire.
5. Always wear chemical resistant gloves, ANSI approved
eye protection, and respiratory protection while using parts
washer. Even water-based cleaning agents, when mishandled,
can present health risk or cause injury.
6. Always operate parts washer in an illuminated, well-ventilated
indoor environment.
OPERATION
1.
Set a standard 5-gallon bucket onto a clean, protected work
surface capable of supporting the bucket and washer at
capacity.
2. Place the pump in the
bottom of the bucket
with the intake facing
the center, and cord
closest to the wall of
the bucket. Press the
top of the pump to
establish suction.
3. Fill the bucket with the
desired amount of cleaning
solution; the pump must be
completely submerged in
order to operate.
4. Place the washing basin onto
the top of the bucket, so that
the power cord and hose
feed through the slotted point
on the basin. If the hose is
pinched, the parts washer will
not operate.
5. Set the cleaning brush into the basin.
6. Plug the pump into a
grounded, GFCI protected
outlet. Cleaning solution will
flow through the brush.
7. After one hour of use, inspect the pump to ensure the pump
is not clogged. Replace the used cleaning solution with new
cleaning solution.
8. When finished, place the brush into the basin, and unplug
the pump. Clean the pump, washer and hose after use.
Dispose of used cleaning solution in accordance with
Federal/State/Local laws.
MAINTENANCE
After each use, check the pump intake. If the intake becomes
dirty and clogged, performance will diminish and may cause
malfunction. To clean the pump, you can remove the casing
over the intake. Ensure all parts are securely attached before
attempting to operate.
STORAGE
Store the portable parts washer in an upright position and in
a clean, dry area. Do not store near flammable items or open
flames.
DISPOSAL
At the end of the useful life of the Portable Bucket-Top Parts
Washer, dispose of the components according to all Federal/
State/Local laws.
