7
Operating Instructions and Parts Manual
24369
DIGITAL BATTERY
ANALYZER
4. When testing older model diesel engines, you may
need to run up the engine to 2,500 RPM for 15
seconds.
5. Press the “ENTER” key to test the charging system
with accessory loads. One of the three results
will be displayed along with the actual testing
measured.
a. “ALT. LOAD VOLTS NORMAL”. The system is
showing normal output from the alternator. No
problem detected.
b. “ALT. LOAD VOLTS LOW”. The alternator is
not providing sufficient current for the systems
electrical loads and the charging current for
the battery. Check the belts to ensure the
alternator is rotating with the engine running.
If the belts are slipping or broken, replace
the belts and retest. Check the connections
from the alternator to the battery. If the
connection is loose or heavily corroded, clean
or replace the cable and retest. If the belts and
connections are in good working condition,
replace the alternator.
c. “ALT. LOAD VOLTS HIGH”. The voltage output
from the alternator to the battery exceeds the
normal limits of a functioning regulator. Check
to ensure there are no loose connections
and that the ground connection is normal.
If there are no connection issues, replace
the regulator. Since most alternators have
the regulator built-in, this will require you to
replace the alternator.
6. Press “ENTER” when charging system test is
completed. Turn all accessory loads and engine
off. Press “ENTER” to return to Step 1 or remove
the test clamps from the battery posts after
completion of testing to end test.
7. The screen will show “TEST OVER. TURN OFF
LOADS & ENGINE”.
LANGUAGE SELECT
1. There are five languages you can select: English,
Chinese, German, French and Spanish.
2. Connect the Battery Tester to a vehicle battery.
3. The tester defaults to BATTERY TEST display.
4. Press “
u
” button twice to get to the LANGUAGE
SELECT display.
5. Press “Enter” button, the display will show all
language options.
6. Press the “
u
” button to select the language you
want.
7. Press “Enter” button to confirm selection and
return to LANGUAGE SELECT display.
ADJUST DISPLAY BRIGHTNESS
1. Connect the Battery Tester to a vehicle battery.
2. The tester defaults to BATTERY TEST display.
3. Press “
u
” button three times to get to the LCD
BRIGHTNESS display.
4. Press “Enter” button to show LCD Brightness in
percentage.
5. Press the “
u
” button to adjust the LCD brightness.
6. Press “Enter” button to save the setting and return
to LCD BRIGHTNESS display.
FAST TEST MODE
1. In fast test mode, the tester will test the vehicle
battery with the parameters saved last time.
Include battery type, battery standard, and battery
capacity.
2. Connect the Battery Tester to a vehicle battery.
3. The tester defaults to BATTERY TEST display.
4. Press “
u
” button once to get to the FAST TEST
MODE display.
5. Press “Enter” button to test the battery.
6. Tester will show “TESTING”.
7. After about 2 seconds, the test data will be
showed on screen. Includes: battery voltage value
and CCA value.
8. Press “Enter” button to return Step 3.
MAINTENANCE
1. Always store the Battery Tester in a well-protected
area where it will not be exposed to inclement
weather, corrosive vapors, abrasive dust, or any
other harmful elements.
2. Keep the Battery Tester clean for better and safer
performance.
3. Clean clamps and case after each use to prevent
corrosion from battery fluid.
05/15
2015 ©OEMTOOLS
