Excavate an extra
space at the side
of the hole to allow
for backfilling. Run
direct burial cable
to each speaker
location and make
connections as
recommended in the “Connection & Setup”
section. Select the desired tap position. Bury
the speaker to the level shown in the image.
WARNINGS
•
Do not place the speakers where the grille will receive direct
high-pressure water spray.
TIPS
To increase their longevity, the speakers can be covered during
winter months in regions that receive large amounts of snow.
When selecting the tap position,
there are two bands of numbers. The
inside band is the 100V scale and the
outside band is the 70V scale. The
values shown are in watts. The most
counter-clockwise position is for use
in 8-ohm systems. The position with
the on the 100V scale is NOT to be
used on 100V systems.
INSTALLATION
Plan your installation. Ensure that
you have access to all speaker
locations and to the sound source.
If desired, install the security
brackets to the bottom of the
speaker as described earlier. Dig
a 13" (33cm) deep hole with an
opening that is 12" (30cm) in
diameter (Installations without
security bracket only require a 3"
(8cm) deep hole.)
Exterior
ST-6 :
6-1/2" In-Ground Landscape Speaker
page 2 of 2
Install Guide
Rev. A
SPECIfICATIONS
Model Number:
ST-6
Woofer:
6.5" Poly w/ butyl rubber surround
Frequency Response:
70Hz - 20kHz
Power Handling:
50W RMS, 100W Max (8-ohm)
Sensitivity:
87dB 2.83V / 1 meter (1W)
(84dB Effective)
Crossover:
Dual-Band Multi-Order Topology
Tweeter:
1" Titanium dome
Impedance:
8 ohms nominal
Available Colors:
Garden Green
Selectable Tap
Positions:
70V: 1, 2, 4, 8, 16, 32W
100V: 2, 4, 8, 16, 32W
Dimensions:
13-7/8" (346mm) Diameter
14-1/2" (368mm) Tall (w/o bracket)
11-1/2" (292mm) Tall (when buried)
Mounting Depth:
12-3/4" (33cm) with bracket,
3" (7.6cm) w/o bracket
Shipping Weight:
14.5 lbs (6.6kgs)
Net Weight:
10.5 lbs (4.8kgs)
To
All taps are in Watts unless otherwise noted.
