INSTALLATION OF C-10SW
Remove the grille with the included Grille Removal Tool. Cut the
white film out of the mounting bracket with a utility knife.
Connect the speaker wires and place the C-10SW up into the
ceiling by holding the black steel installation handle as shown in
Figure 3
.
Overall
Cut-Out (Round x Depth)
C-10SW
12-7/8" round
11-1/2" x 4-5/8"
Figure 4
Figure 3
For
C-10SW
&
MB-C10
In-Ceiling Subwoofer
CAUTION:
THIS
INSTALLATION
HANDLE MUST
BE REMOVED
BEFORE THE SUB
IS ACTIVATED
Use the guides shown below in
Figure 4
to align the speaker
frame with the mounting bracket.
Attach the speaker to the mounting bracket with the four black
screws that are included with the C-10SW.
Remove the installation handle by loosening the two screws
that hold it in place and turning it so that the screw heads pass
through the keyhole openings.
Tighten the two screws that held the handle in place.
Attach the grille with spun cellulose insert. The white
insert goes between the driver and the grille to improve the
appearance.
MB-C10 Package Contents
MB-C10
Package Contents
Figure 1
Item 1
Item 2
Eight (8) short screws (Item 1)
Eight (8) longer screws (Item 2)
MB-C10
with white film cover
C-10SW
Subwoofer w/ grille
Four (4) Speaker
Mounting Screws
Grille Removal
Tool
Speaker Mounting Handle
NOTE:
The MB-C10 and the C-10SW
are
sold separately
so that they may be
purchased and installed during different
phases of construction.
C-10SW
Package Contents
Two (2) pairs of steel
mounting rails
page 2 of 2
Rev.B