3
Operating Instructions and Parts Manual
27090
9/21
2021 OEMTOOLS
®
BRAKE ANCHOR PIN PRESS
SPECIFIC SAFETY INSTRUCTIONS
AND WARNINGS
The following safety information is provided as a guideline
to help you operate your Brake Anchor Pin Press Tool
under the safest possible conditions. Any tool or piece
of equipment can be potentially dangerous to use when
safety or safe handling instructions are not known or
not followed. The following safety instructions are to
provide the user with the information necessary for
safe use and operation. Please read and retain these
instructions for the continued safe use of your tool.
Failure to follow instructions listed below may result in
serious injury. In addition, make certain that anyone who
uses the equipment understands and follows these safety
instructions as well.
WARNING
:
1. Always keep the forcing screw well lubricated.
2. DO NOT exceed the maximum recommended torque
for each forcing screw.
NOTE
: Exceeding these torque values may shorten the life
of the forcing screws. The forcing screws are consumable
items and are NOT covered under warranty.
OPERATION INSTRUCTIONS
A. ANCHOR PIN REMOVAL
1. Install the Centering Bushing onto the back side of the
anchor pin shoulder.
2. Position the C-Frame over the anchor pin (and
Centering Bushing) and tighten the Forcing Screw by
hand until the anvil contacts the front side of the anchor
pin.
3. Apply force with a 1/2" impact wrench until the anchor
pin has been removed. (Note: Centering Bushing may
push out the C-Frame, this is normal.)
B. BUSHING REMOVAL
NOTE
: In the event you are servicing a stamped spider, a
punch and chisel may be required to remove the bushing.
1. Install the magnetized bushing adapter onto the anvil.
2. Position the C-Frame over the bushing in the spider so
the “step” in the bushing adapter seats inside of the
bushing.
3. Apply force with a 1/2" impact wrench until the bushing
has been removed
.
Figure
Description
Qty.
A
C-Frame
1
B
Extension Bar
1
C
Forcing Screw
1
D
Centering Bushing 1
E
Bushing Remover
1
F
O-Ring #2-012
1
G
O-Ring #021
1
PRODUCT LAYOUT
PARTS LIST
A
B
C
D
E
G
F
