6
Operating Instructions and Parts Manual
24492
20V MAX* LI-ION CORDLESS
ANGLE GRINDER
11/18
2018 OEMTOOLS
™
WARNING
Never use your angle grinder with the guard removed. It
has been designed for use only with the guard installed.
Attempting to use the angle grinder with the guard
removed will result in loose particles being thrown against
the operator resulting in serious personal injury.
WARNING
Never use your angle grinder without eye protection.
Following this rule will reduce the risk of serious
personal injury.
4. The efficient operation of the angle grinder begins
by controlling the pressure and surface contact
between the grinding disc and the workpiece. Flat
surfaces are ground at an acute angle, normally
between 5° and 15° (Fig. 6).
1
Fig. 2
Fig. 5
Fig. 1
Fig. 3
Fig. 4
Fig. 7
Fig. 6
5. For maximum control, hold the angle grinder
in front and away from you with both hands,
keeping the grinding disc clear of the workpiece.
Start your angle grinder and let the motor and
grinding disc build up to full speed. Gradually
lower the angle grinder until the grinding disc
contacts the workpiece.
6. For best results keep the angle grinder tilted at
an angle of between 5° and 15° degrees and
continuously moving at a steady, consistent
pace. Move the angle grinder back and forth or
up and down over the work area. Keep the angle
grinder moving so that an excessive amount of
material is not removed from one area. If the angle
grinder is held in one spot too long, it will gouge
and cut grooves in the workpiece. If the angle
grinder is held at too sharp an angle, it will gouge
the workpiece because of the concentration of
pressure on a small area.
CHARGING THE BATTERY PACK:
1. Place the charger in a dry location near a 120V/60
Hz electrical outlet.
2. Plug the charger into the electrical outlet.
3. The green LED light will turn on.
4. Turn the battery pack upside down and slide it onto
the charger.
5. The green LED light will turn off and the red LED
light will begin to flash indicating the battery pack
is charging.
6. The red LED light will turn off and the green LED
light will turn on when fully charged.
7. Once the battery pack is fully charged, remove the
charger plug from the power source and remove
the battery pack from the charger.
NOTE: DO NOT charge batteries when the work area
or the battery temperature is at or below 32° F (0° C)
or above 113° F (45° C).
Green
Light
Red Light
Battery on
the Charger Charging Status
ON
OFF
NO
Charger connected to power supply
OFF
FLASHING
YES
Battery charging
ON
OFF
YES
Battery fully charged
OFF
ON
YES
Battery defective or bad contact
ON
ON
YES
Battery too hot or too cold to be charged
