2
SETTING UP THE REMOTE CONTROL
CHARGING THE RIPPER’S BATTERY
OPERATING THE RIPPER
Tip. For best results the car needs to be within a 150 foot range of the controller.
Tip. Full charge takes up to 3-4hrs
1. Remove the battery from The Ripper
as shown in the setting up instructions.
2. Connect The Ripper’s battery to the
USB charging cord connector.
3. Plug the USB cord into a 5v1a USB
charger.
4. The charger light will turn on to indicate charging. When the charger light
goes out charging is complete and you can reinstall the battery in The Ripper.
Controller Functions
1. Using a phillips screwdriver open the
battery cover on the base of the
controller.
2. Install 4x new AA batteries taking care
to match the correct polarity (+/-).
3. Close the battery cover.
Steering Wheel
(Left & Right Turning)
Forward & Reverse Throttle
Controller
On/Off Switch
Max. Speed Control
Transmit
Indicator Light
Steering Trim
Adjustment
Controller On/Off
Indicator Light
Adjust Steering
Sensitivity
USB Charging Cord
LiPo
Battery
AA Batteries