ENCLOSED TREATMENT INSTALLATION INSTRUCTIONS
2
3
4
CLEAN
Stand treatment upright. Fully raise the treatment.
Clean the inside glass of the treatment assembly and
the window on the door.
2
TOP BRACKETS
Slide left and right top brackets behind the door frame on
each top corner until the wings at the top and outside end
are flush against the frame. Tighten the top screws.
LOOSEN SCREWS AND INSERT SPACERS
Loosen frame screws at the top and bottom corners (some snap
frame windows do not have screws). If the screws on your window
have plugs over them and do not easily come out, use a wood screw
and turn it into the plug. Turn the wood screw into the plug until it
comes out. Push spacers in behind the lower corners of the frame,
(approximately 14" up from the bottom for the 36" unit, 11 1/2" up
from the bottom for the 64" unit) until tab is flush with the frame.
Tighten bottom screws.
