8
MAINTENANCE
In case of malfunction or damage to the appliance or a part of it, the
appliance must be analysed by the manufacturer or the relevant technical
assistance or in any case by a person with similar skills in order to prevent any
risk. The user must not disassemble the device him/herself.
GENERAL CLEANING
It is recommended to clean daily or after every use. Check that the appliance is off
and disconnected from the power mains.
• Avoid all risk of electric shock by not cleaning the appliance with water and do
not immerse it in water.
• Do not use abrasive solutions or concentrated detergents.
• Clean the exterior with a soft cloth or slightly damp cloth.
• After use, make sure that all parts are completely dry.
Removing and cleaning the blade block
• Turn off the appliance.
• Remove the hair residues from the head using the brush
L
(fig. 1).
• Lubricate the head with the special oil (Fig. 4).
• Turn on the appliance briefly to ensure an even distribution of the oil film.
Maintenance, replacement and adjustment of the head
The head components can be sharp. Take particular care during the
whole procedure.
• Unscrew the screws of the head (fig.
2
).
• Release the head levering in the slot
R
(fig.
3
) located below the head.
• Slide the blade
O
outwards (fig.
2
) to release it from the comb
N
(fig.
2
).
• Clean all parts of hair from residues.
• Apply two to three drops of lubricant oil (fig.
4
)
• Reassemble by re-inserting the blade.
• Re-attach the head to the supports, making sure that the metal springs
Q
(fig.
2
)
engage correctly in the slot
S
(fig.
2
) of the blade support
P
(fig.
2
)
• Tighten the screws to firmly attach the head to the body.
• You can adjust the cutting length of the head (zero gap) by the distance between
fixed blade
N
(fig.
2
) and moving blade
O
(fig.
2
).
• After unscrewing and releasing the entire blade assembly, loosen the internal
screws
T
slightly, making sure not to fully unscrew the screws (fig.
2
)
• Adjust the moving blade
O
(fig.
2
) until he desired distance of the moving blade tips
from the fixed blade
N
(fig.
2
) tips are achieved (fig.
2
).
• Before tightening the screws, check that the blade is aligned laterally with the
comb (Fig.
2 - b/c
). To avoid the risk of skin injuries when using the appliance
align the comb so that between the front edge of the comb and the front edge of
the blade there is a minimum distance of 0.1-0.5 mm (Fig.
2 - a
).
• Tighten the internal screws
T
firmly (fig.
2
).
• Reattach the blade assembly to the body of the unit as previously explained and
screw back into place.
• Before using the appliance, check that it is working properly.
ENG