Hardware reset
The PC–600 has a push button which allows you to reset the system
without turning off the power. Connector J7 also provides a reset by
closing a circuit between pins 1 and 2. These methods provide a more
complete reset than the <CTRL><ALT><DEL> method. The RESET
command also accomplishes the same thing as the reset button and reset
connector. Refer to the component diagram in the
Quick start
chapter for
the location of the reset button.
WARNING!
When using COM1 as the console, the <CTRL><ALT> <DEL>
commands on the host system keyboard only reset the host
system. Use the RESET command to issue a hardware reset
on the PC–600.
Table 16–1 Reset connector: J7
J7 – reset connector
Pin #
Pin Name
1 Reset
2 Gnd
Note
See
Appendix A - Connectors
for mating information.
104
