20
Maintenance
Adjust Lock Levers
If the pan and / or tilt friction locks do not fully engage at the end of
the lock lever travel, adjust the lever position as follows:
1. Rotate the lock lever to the locked position.
2.
The lock lever is attached by means of a screw. Carefully peel
away the lock label to expose the screw. Using Hex key, remove
the screw
3.
Pull the lever off the hexagonal shaft, rotate it approximately 30°
away from the “locked” end of the travel, and reinstall it.
4. Tighten the screw. Reapply the lock label.
1
Lock Shaft
2
Tilt Lock Lever
3
Screw
4
Lock Label
1
2
3
4
