9
5.
Once you are satisfied that the unit is fully tightened to the hull, you will notice that sealant has
squeezed out from around the perimeter of the light. Using a cloth wipe off excess sealant to leave
a clean seal. If you do not see sealant squeeze out from the body, you have not used enough sealant
or tightened the unit enough to the hull. Carefully examine the installation to make sure the seal you
have installed on the unit is fully water-tight. If in doubt, remove light, re-apply sealant and re-install.
2.3 - Connecting the light fixture
X8 Colours & X16 Colours:
The X8 & X16 Colour change models can either be used in DMX mode (using the OceanDMX controller
kit) or simple DC switch mode, where a simple toggle of the power switch can be used to change colour
modes. To use in DC switched mode; connect V DC power +Ve to the RED wire, -Ve to the BLACK,
BROWN & YELLOW wires:
For connecting X Series Lights with the OceanDMX X Series Controller Kit, please refer to the OceanDMX
Installation Manual. Note that when using with the DMX controller, the cable from the light to the junction
box cannot be extended.
WARNING:
Always consult a qualified electrician when connecting OceanLED light fixtures. When
connecting light units, please note that all OceanLED lights will operate within a specific voltage range.
Connecting lights to your V DC power source
It is recommended to connect the light to the DC power source using a two pole, screw type terminal
block with a minimum voltage rating of 50V and a current rating of at least 5A. The ends of the cable
should be stripped back (if required) and suitable ferrules fitted. The terminal block should be fixed inside a
waterproof enclosure (IP66 minimum).
TIP:
Switch and breaker need to be robust enough to support light.
TIP:
For complete instructions on V DC connections, please refer to ABYC codes of practice and other
applicable codes and ordinances for V DC connections.
WARNING:
Never leave the bare cables unprotected. Take care to not leave the bare wire ends in bilge
water before making the waterproof connections. Water deposits in the connectors and cables will
cause corrosion. Over time water can also work its way into the unit along the inside of the cable due to
capillary action causing the light to fail. This will NOT be covered under warranty.
1.
Depending on the model of lights currently installed you will need to pull the correct sized power
cable from the breaker/fuse panel to the light locations to supply constant power to the units. It is
imperative that the correct sized tinned boat cable is used. (Please Refer to Cable Gauge Chart in
the Appendix)
2.
Using waterproof connections or a waterproof junction box, make the connections at either end of
the system to attach the lights to the vDC system. Red is +Ve, Black is -Ve.
NOTE:
Corrosion of wire, and/or water ingress into the light unit via cable is NOT covered under warranty
.
