17
9.
Replace the locking cap on the mounting tube and secure tight using the locking tool (2) provided with
the light as shown in the image below.
10.
Connect the bonding cable to the remaining screw (3) and lock in place with the nut and shake proof
washer provided. Tighten the locking screw using a 4mm Allen key, applying thread lock at point
of thread contact with locking ring.
Bonding
: The light
MUST
be attached to the vessels bonding /
cathodic protection system. Once fitted it is mandatory to check that there is full continuity between
the vessels cathodic protection system and the outer bezel of the mounting tube assembly (see
bonding schematic – chapter 7 Appendix).
11.
See Chapter 5 for driver installation information.
MAINTENANCE
FOR TIPS ON REMOVING THE INSERT, PLEASE REFER TO THE MAINTENANCE AND REPAIR SECTION IN
THIS GUIDE.
OceanLED INSTALL / ALLURE / 240717 / 7.1
