Sauna & Steam
Oceanic Saunas 01902 450 550 [email protected]
5
3 Way Fragrance Pump Manual
3. Install and Operate
Figure
2
i. Install the pump in close proximity to the steam generator with a suitable power supply for
the mains adapter. Note that the fragrances should be positioned at least 50 cm above the
pump.
ii. Fix the fragrance pump onto dry wall using screws and plugs.
iii. Use the regular 15mm plastic hose to connect the between the fragrance storage vessels
and 3 input ports as shown in fig 2. Then insert the T piece into the steam output line from
the steam generator and connect the output port of the fragrance pump using the high
temperature silicon rubber hose make sure all the connections are tight so that there are no
leaks and that none of the pipes are kinked or form a trap which could cause a restriction to
the flow.
iv. Remove the protective silicone covering and attach the temperature sensor to steam pipe
covered with insulation cotton or a jubilee clip then connect the pin into socket of fragrance
pump.
v. Once the fragrance bottles are full and lying down, puncture a hole in the top of the bottles
to allow an air flow.
6) Connect the transformer outputs to the input ports I and II. Connect the transformer to power
supply.
