Sauna & Steam
Oceanic Saunas 01902 450 550 sales@
oceanic-saunas.co.uk www.oceanic-saunas.co.uk
6
Stauna Manual
Important Notice: Please pay close attention to the drawing Fig. 1 below. The mains power
is solely supplied to the OC-ST control and is diverted from here to the heater and steam
generator . You must not wire directly from the mains to either the sauna heater or mini
steam generator.
5. Installing the Sauna Heater
i. Confirm the model you have selected is suitable for your sauna room, please refer to the table
below.
ii. Ensure the power supply is suitable for the sauna heater, refer to the table below.
iii. The installation position must comply with the minimum distance in the table below and in
the diagrams on the following pages.
iv. The minimum height of your sauna room must be 1900mm, please refer fig 3c
v. Do not install the sauna heater on the floor or in a cabinet
vi. Do not cover the sauna heater back with asbestos cement or similar material
vii. The wires which enter the sauna room must be rated to150
o
C- type 60245 IEC 66 HO7RN-F
(BSEN 6141) please refer to table below. (The signal cable between control box and mini steam
generator does not need to be changed to the silicone cable as long as it does not enter the
cabin higher than 500mm from the floor.)
viii. Do not install two or more sauna heaters in one sauna room.
ix. The sauna heater becomes very hot when operating and must be guarded to protect incase of
accidental contact, please see the sizes in fig 3d and also refer to charts below.
x. The upper supporting screws must be fixed tightly, there is a 3mm gap between the screw
head and wall (refer fig 3a, fig 3b), additional retaining screws should be inserted into the
round holes to prevent the heater being lifted.
xi. Temperature sensors should be installed in sauna room but not directly above sauna heater,
the height must be a minimum of 1800mm from floor. The horizontal distance to sauna heater
must exceed 500mm.
xii. Wash the rocks thoroughly before filling the basket. Discard any with veins running through or
any rocks smaller than 50x50mm.
xiii. Fill the rocks loosely around the elements, try to use the larger rocks between the elements
and use the smaller ones for the top.
xiv. To prolong the life of your sauna you can use a heat proof board behind and above the heater
to prevent charring, for commercial cases this should be more seriously considered.
Model
Sauna Room
Clearance Distances (mm)
Current (A)
Fuse (A)
Volume (m
3
)
Min
height
Distance to shelf
over 500mm
Ceiling Floor
230V
1N~
400V
3N~
230v
1N~
400V
3N~
Min
Max
OCS45
4
6
1900
80
1100 180
19.5
6.5
25
10
OCS60
5
8
1900
150
1100 180
27
9
32
16
5.1. Sauna Heater Unit Parameters
Sauna Heater Dimensions 410 x 280 x H570mm
